![]() (I also received TIA v17 but I will hold off. 6ES7810-4CC11-0YA5 Upgrade License SIMATIC STEP 7 Upgrade Standard V5.3, V5.4, V5.5 to V5.6 SP1 1. The entire Step 7 installation is pretty much trashed, so I will have to revert to a disk image.Ĭan anyone offer any insight? (I’ll contact Siemens as soon as I can, obviously.) Either way, I'd hold off on installing this. SIMATIC STEP 7 V5.6 SP1 Single Floating License DVD Boxed version with DVD and USB license media Order No. ![]() SIMATIC STEP 7 V5.6 is the proven programming software for the controller families S7-300, S7-400, C7 and WinAC. SIMATIC STEP 7 is the worlds best known and most widely used engineering software in industrial automation. I have 2008 SP5 UPD2, which I believe to be the latest. STEP 7 V5.x - the proven solution with tried and tested functionality. It complains about WinCC Flexible not being installed. I can also not open a project from within Starter. I have version 5.4 hotfix 2, which seems to be the latest. But the link in the PDF to article 109794089 leads to a 403 forbidden.Īlso, it complains about Starter not being installed. If it was project-oriented, those projects now are read-only and the messaging can't be switched without that package. ![]() I am not using project messages but the setting prior to the upgrade seems important. ![]() A license was included, but the software itself was not. What has Changed hotfix 1 for STEP 7 V5.6 Compared to Version STEP 7 V5.6 Installation of hotfix 1 for STEP 7 V5.6 As of this hotfix: If after installing a hotfix 1 for STEP 7 V5.6 the original installation is changed with 'Change program' or 'Repair program' the hotfix needs to be installed again. Only afterward I noticed a PDF pointing out that it requires Simatic S7-PM Project Messages. I made the fatal mistake of installing Step 7 Professional 2021 (5.7) via SUS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |